Table of Contents
Advertisement
HOW TO REMOVE/ATTACH PARTS
Caution
● Before removing parts, take out all the foods on the parts.
● Do not remove parts except the ones listed here.
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
R-D6800 Type
How to remove
Pull the door, lift the Vacuum Case with a door at
the edge of it lightly, and then pull it out, jiggling
it up and down.
60
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.
Fixed shelf
R-D6200 Type
Height adjustable upper and middle shelf
Slightly lift up the
back of the shelf
and draw it.
Forks of the
shelf
When installing the shelf, slide it until it reaches to the interior wall, then
slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Caution
Door may damage if drawing the shelf without turning it.
Be careful to attach/remove the glass shelf because it is heavy.
If it drops, it may break and cause bruise or injury.
Lift up the door pocket while
tapping the left/right of its
bottom surface, and remove
it.
(It is fixed a little tightly.)
Insert the door pocket fully to the end
when installing it.
Height adjustable lower shelf
Slightly lift up and pull out.
R-D6800 Type
Vacuum Case
How to attach
Insert the Vacuum Case (with the door) so that
both right and left convex ribs on the case
can slide under the guide rail of the Vacuum
Container.
Lastly, hold down
the handle to
lock.
Convex rib
(Glass shelf)
Raise the shelf as shown
in figure, and turn it and
remove it.
Door pocket
R-D6200 Type
Tap
Tap
Guide rail
Advertisement
Chapters
Table of Contents
