Table of Contents
Advertisement
HOW TO REMOVE/ATTACH PARTS
Before removing parts, remove any food inside.
●
Caution
●
Do not remove parts except the ones listed here.
Please contact a Hitachi customer service center if you wish to remove and clean such parts.
Do not remove the platinum catalysts in the Vacuum Compartment and Vegetable Compartment. Also, do not
●
wash them with water.
E
C
D
F
G
I
J
B
Height adjustable lower shelf
Lift up the whole shelf a little
and remove it.
Height adjustable lower shelf
Fixed shelf
shelf partition
Gently tap the left and right sides at the bottom and lift to remove.
(The door pockets are fixed firmly)
When attaching, attach them firmly as far as they will go.
Caution
If they are not attached properly, they may come off and fall, resulting in injury.
How to remove
Pull out the Vacuum Case, lift the front
lightly and pull it diagonally upward.
64
A
E
B
Upper
shelf
H
Middle
shelf
C
Fixed shelf
First remove the height adjustable
lower shelf, and while holding the
shelf partition, lift the back of the
shelf a little and pull it toward you.
F
A
Height adjustable upper and middle shelf
To remove the shelves, remove the upper shelves first, then remove
Request
the lower shelves.
To attach the shelves, attach the lower shelves first.
1
Lift the back of the shelf a
little and pull it toward you.
The glass shelves are heavy. Be careful when removing/attaching them.
Caution
If a shelf falls, you may be injured or the shelf may break.
1
E
Door pockets
Vacuum Case
How to attach
Slide the left and right
protrusions of the Vacuum
Compartment under the
guide rails of the vacuum
container. Finally, lower
the handle to lock.
Protrusion
Make sure that the Vacuum Case is correctly attached by
Request
moving it in and out several times after attachment.
2
3
Raise the shelf as
shown in the drawing.
D
Shelf partition
2
Hold the back and
rotate it toward you.
Vacuum
container
Pg .76
Rotate and
remove it.
Remove it while
pushing it inward.
Tap
tap
Guide rail
Vacuum Case
Advertisement
Table of Contents
