How To Remove/Attach Parts; Height Adjustable Upper And Middle Shelf (Glass Shelf); Door Pocket; Fixed Shelf - Hitachi R-F7300XS How To Use Manual

HOW TO REMOVE/ATTACH PARTS

Caution ● Before removing parts, take out all the foods on the parts.
● Do not remove parts except the ones listed here.
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
R-F6800X, R-F6800 type
How to remove
Pull out the Vacuum Case by slightly lifting up
and moving up and down.
70
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.

Fixed shelf

R-F7300X, R-F6200 type
Forks
Height adjustable upper and middle shelf
Slightly lift up the
back of the shelf
and draw it.
When installing the shelf, slide it until it reaches to the interior wall, then
slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Notice
Door may be damaged if you draw the shelf without turning it.
Be careful to attach/remove the glass shelf because it is heavy.
If it drops, it may break and cause bruise or injury.
Lift up the door pocket while tapping the left/right of its
bottom surface, and remove it.
(It is fixed a little tightly.)
Caution
Insert the door pocket fully to the end when installing it.
If it drops, it may break and cause bruise or injury.

Height adjustable lower shelf

Slightly lift up and pull out.
R-F6800X, R-F6800 type
Forks
Caution

Vacuum Case

How to attach
Insert the Vacuum Case so that both right and left
convex ribs on the case can slide under the guide
rail of the Vacuum Container.
Lastly, hold down the handle to lock.
Vacuum Container
Convex rib
Raise the shelf as shown
in figure, and turn it and
remove it.
Forks of the
shelf (Right /
Left)

Door pocket

R-F7300X, R-F6200 type
If you pull out the shelf straight, it may hit the door.
Request
Guide rail
Check that it is fixed properly
by taking it in and out a few
times.
Vacuum Case
(Glass shelf)
Tap
Tap