Ice Maker Cleaning - Hitachi R-D6800S How To Use Manual

MAINTENANCE
Warning

Ice Maker Cleaning

Be sure to check the followings before
starting the operation.
Go to the next step after checking them.
1
Close all the doors.
2
Touch
All indicator lamps turn on once, and then the current settings are displayed.
3
Hold down
sounds.
When the 3 indicator lamps " Quick " , " Normal " and " Off " start to blink and alarm starts to sound, stop holding
the button.
" Ice Maker Cleaning " (water supply route) starts (for about 3 minutes).
・ The indicator lamp will flash and the buzzer will sound for about 3 minutes.
・ " Ice Maker Cleaning " can ' t be interrupted.
・ If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning may not work properly. Do
not open or close the door until cleaning is completed.
・Door alarm sounds even if alarm is disabled.
4
Put a clean towel, etc. under the Ice Case after the alarm and
blinking of the indicator lamp end, and then remove the Ice Case.
Use a water-absorbing towel under the Ice Case to prevent water after cleaning from spilling out of the
cutout of the Ice Case.
5
Wipe off water inside the Ice Case completely, and then set
it to the Ice Compartment.
Remove the Ice Case, wipe off water inside the Ice Case, and then remove the towel.
There is no problem with using water remaining in the water supply container, if any.
After " Ice Maker Cleaning " , it is set to " Normal " mode, etc.
58
(CONTINUED)
● Do not place your hand in the mechanical section
of the automatic ice maker.
(Rotation of the ice tray may cause injury.)
When using for the first time
button on the Control Panel to turn on the indicator lamp.
button for 5 seconds or more until the alarm
Pg.54
When not used for more than one week
Water supply container
・Water is filled in it up to the limit line.
・ The container is set properly as
specified.
Ice case
・If there remains ice, remove it.
1 1 - 4
It blinks
Touch it
Cutout
Towel