How To Remove/Attach Parts; Height Adjustable Upper And Middle Shelf; Door Pocket; Fixed Shelf - Hitachi R-E5000S How To Use Manual

HOW TO REMOVE/ATTACH PARTS

Caution ● Before removing parts, take out all the foods on the parts.
● Do not remove parts except the ones listed here.
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
How to remove
Pull the door, lift the Vacuum Case with a door at
the edge of it lightly, and then pull it out, jiggling
it up and down.
60
BB0040171T_R-E5000SHV_A.indd 60

Fixed shelf

Vacuum Case

Height adjustable upper and middle shelf

Slightly lift up the
back of the shelf
and draw it.
Forks of the
shelf
When installing the shelf, slide it until it reaches to the interior wall, then
slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Caution
Door may damage if drawing the shelf without turning it.

Door pocket

Lift up the door pocket while
tapping the left/right of its
bottom surface, and remove
it.
(It is fixed a little tightly.)
Insert the door pocket fully to the end
when installing it.
Caution
If it drops, it may break and cause bruise or injury.

Height adjustable lower shelf

Slightly lift up and pull out.
Caution
If you pull out the shelf straight, it may hit the
door.
How to attach
Insert the Vacuum Case (with the door) so that
both right and left convex ribs on the case
can slide under the guide rail of the Vacuum
Container.
Lastly, hold down
the handle to
lock.
Convex rib
Raise the shelf as shown
in figure, and turn it and
remove it.
Tap
Tap
Guide rail
15.4.7 1:50:45 PM