Transporting Your Refrigerator (Transport For Moving) - Hitachi R-D6800S How To Use Manual

Peel off the seal from the Fresh Cassette in the Vacuum Compartment.
4
Peel off the seal from the Fresh Cassette set in front of the
Vacuum Compartment before use.
● Hot flavor will not be released until the seal is peeled off.
Caution ● Do not wash it in water.
● Avoid to sniff the odor directly.
5
On the Power Plug.
It is not a problem to plug in the power cord soon after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 220-240V, rated 10A or more)
Cooling inside the refrigerator starts.
● It may take more than 4 hours to cool well the inside of the refrigerator, depending on conditions such as the ambient
temperature or storage state of foods. It may take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
● Perform " Ice Maker Cleaning " when using the automatic ice making function first.
● A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the first time, it may take 24 hours and more to make ice.)
● After the power plug is inserted, the motor continues to work for about 3 minutes to check the state of the automatic
Notice
● It may smell of plastics in the beginning when you start to use. Keep the room well-ventilated. Such smell will
Caution ● If you wish to install the refrigerator in a hot spring area exposed to sulfide gas, you may need
● Do not peel off the seal on the back or plastics at the lower part of the side.
● When a magnet or suction cup is attached on the side of the body or the surface of a door, it

Transporting your refrigerator (transport for moving)

1
Take out foods or ice.
2
Pour off the water from the water
supply container/ice tray.
3
Pull off the power plug.
No problem just before move.
4
Remove the leg covers, and raise the
adjustable mounts.
5
Use a tape to secure the door/power
cord.
6
Place a sheet or cloth for protection
when moving / transporting it.
To prevent damage to the floor material or water from spilling out.
ice maker, cool air flap and refrigerant valve (it may sound louder than usual, but it means no trouble).
disappear gradually.
to apply anti-rust treatment to the piping. Contact your dealer in advance. Failure caused by
sulfide gas will not be covered under guarantee.
may leave a mark.
Pull it out right above.
Pg.58
Place a sheet or cloth
7
for protection first, and
then lay it back to drain
water.
8
Make sure to hold the
handles when carrying
it with 2 to 4 persons.
Do not lay it down horizontally for
transportation (which may cause
failure of the refrigerator).
9
See " Preparation before use " for
installing the refrigerator in a new
location.
Pg.42
Peel off the seal, and then return
it back.
Stickers
Plastic parts - Left/Right
Such as old cloth
43