Deliming - Jackson DISHSTAR Series Installation, Operation And Service Manual

OPERATION

DELIMING

If the machine is equipped
with an SPS and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, see the Scale
Prevention System page.
At any time during
Delime cycle, pressing
power button will
drain and turn
off the machine.
07610-004-99-71-B
OPERATING INSTRUCTIONS
To maintain the machine at its optimum performance level, lime and corrosion
deposits must be removed. The frequency for deliming will be based on water
conditions. A deliming solution is available from your chemical supplier. Read and
follow all instructions on the label.
To delime the machine:
1. Remove rinse arms and place in sink with deliming solution (leave for amount of
time recommended by chemical supplier).
2. Replace rinse arms.
3. If the machine is full of water, close door, press power button, and allow the
machine to drain and shut-off.
4. Follow Filling the Wash Tub section of this manual.
5. Open door and add amount of deliming solution recommended by chemical
supplier.
6. Close door and use cycle button to select Delime.
°
155
7. Press start button and the machine will begin delime cycle. Cycle timer shows on
right display. LED on power button will turn green.
°
155
8. The machine will delime, drain, and refill. When cycle is complete right display
will turn off.
9. Wait five minutes and inspect the machine. If the machine is not delimed,
run again.
10. When clean, use cycle button to select Normal.
°
155
11. Press start button and run two Normal cycles to remove residual deliming
solution.
°
155
12. The machine is now ready for normal operation.
F
F
F
F
299
15