Mita DP-2800 Service Manual page 7

•Check that the power cable covering is free of damage. Check that the
power plug is dust-free. If it is dirty, clean it to remove the risk of fire or
electric shock. ........................................................................................
•Never attempt to disassemble the optical unit in machines using lasers.
Leaking laser light may damage eyesight. ............................................
•Handle the charger sections with care. They are charged to high
potentials and may cause electric shock if handled improperly. ............
CAUTION
• Wear safe clothing. If wearing loose clothing or accessories such as
ties, make sure they are safely secured so they will not be caught in
rotating sections. ...................................................................................
•Use utmost caution when working on a powered machine. Keep away
from chains and belts. ...........................................................................
•Handle the fixing section with care to avoid burns as it can be
extremely hot. ........................................................................................
•Check that the fixing unit thermistor, heat and press rollers are clean.
Dirt on them can cause abnormally high temperatures. ........................
•Do not remove the ozone filter, if any, from the copier except for
routine replacement. ..............................................................................
•Do not pull on the AC power cord or connector wires on high-voltage
components when removing them; always hold the plug itself. .............
•Do not route the power cable where it may be stood on or trapped. If
necessary, protect it with a cable cover or other appropriate item. .......
•Treat the ends of the wire carefully when installing a new charger wire
to avoid electric leaks. ...........................................................................
•Remove toner completely from electronic components. ........................
•Run wire harnesses carefully so that wires will not be trapped or
damaged. ...............................................................................................