Downloading Data From A Memory Card - Mita DP-2800 Service Manual

5A2
When downloading finishes, the display reverts to
Supervisor mode. In this state, turn power off.
Turn power on again. Check the display shows Ready.
If not, refer to section Errors during downloading on page
Chapter 3-14.
Caution: Downloading controller firmware takes several minutes (depending on the
processing speed of the computer used). Do not turn power off during downloading.
Confirm the status page shows the new firmware version (See Appendix B , page B-4). If the
message display indicates Call service person Dn ( n =0, 1, ...) , refer to section Errors during
downloading on page Chapter 3-14.

Downloading data from a memory card

To download data written in a memory card to the printer, proceed as follows. Data in a
memory card can be selectively downloaded when the Prescribe RWER command is used.
Refer to the Prescribe Command Reference Handbook in the CD-ROM purchased with the
printer for details about the RWER command.
Perform in sequence:
Insert the memory card in the printer's memory card slot
of the printer.
Turn printer power on. The printer automatically reads
data in the memory card, indicating Downloading on
the message panel during downloading.
When the data is successfully read, the message display
indicates Supervisor mode.
Turn printer power off.
Remove the memory card from the printer.
Turn printer power on again. Check the display shows
Ready.
Confirm the status page shows the new firmware version (See Appendix B , page B-2). If the
message display indicates Call service person Dn ( n =0, 1, ...) , refer to section Errors during
downloading below.
3-14
Supervisor mode
Ready
Relevant display
Downloading
Supervisor mode
Ready