Setting Methods; Default Settings - Omron V680-CA1D User Manual

Setting Methods

Use the provided screwdriver to make switch settings as shown in the following diagram.
• Rotary switch settings

Default Settings

The following table shows the default settings (factory settings).
SW1 SW2
1 O
2 N
3
4
5
6
7
8
SW3 (left)
1 O
2 N
3
4
5
6
7
8
SW4 (right)
Name
SW1 Node number
SW2 Reserved by the system.
SW3-1 Reserved by the system.
SW3-2 Reserved by the system.
SW3-3 Reserved by the system.
SW3-4 Reserved by the system.
SW3-5 Reserved by the system.
SW3-6 Reserved by the system.
CD1D Not used.
SW3-7
CD2D RS-485 terminating resistance
SW3-8 Reserved by the system.
SW4-1 Baud rate
SW4-2
SW4-3 Data length
SW4-4 Parity
SW4-5
SW4-6 Number of stop bits
SW4-7 Reserved by the system.
SW4-8 Reserved by the system.
Before Communications
• DIP switch settings
Default setting
0 Node number 0
0 Set to 0.
OFF Always OFF
OFF Always OFF
OFF Always OFF
OFF Always OFF
OFF Always OFF
OFF Always OFF
(Not used.)
OFF
No terminating resistance
OFF Always OFF
OFF 38,400 bps
OFF
OFF 7 (ASCII7)
OFF Even
OFF
OFF 2
OFF Always OFF
OFF Always OFF
Heat-resistive RFID System
Section 3
Details
39
User's Manual