Tags
The Tags have a limited life span. Therefore, install them in locations in which they can be easily
replaced. Use the following procedure to mount the V680-A80 Attachment when required.
1.
Mount the Attachment to the workpiece.
Use a tightening torque of 21 to 42 N·m.
2.
Tighten the lock nut.
3.
Mount the Tag to the Attachment.
The Tag can be mounted in either direction.
4.
Insert the split pin into the 3.2-dia. hole and open the tip of the
pin to secure.
Two nuts and one split pin are provided with the V680-A80 Attachment. Replacement split pins must be
provided by the user.
Installation, Connections, and Wiring
Nominal: 3.2 mm × 20 mm (length)
Split pin
Heat-resistive RFID System
Section 2
23
User's Manual