Section 2
Installation, Connections, and Wiring
Wiring the RESET Signal and External Input Signals (IN1 and
IN2)
• Crimp Terminals
The I/O terminals use M3 self-rising screws. The following type of crimp terminals can be connected to
these terminals.
6.5 max.
(For M3 screws)
Tighten each screw to a torque of approximately 6 kgf·cm.
Make sure that the input voltage does not exceed a maximum allowable input voltage of 26.4 V, otherwise the Controller
may malfunction.
Separate power lines and high-tension lines from the input line to protect the input line from noise interference.
Heat-resistive RFID System
28
User's Manual
V680-CA1D
RESET
24 VDC
input
V680-CA1D
24 VDC
IN2 input