Section 2
Installation, Connections, and Wiring
• Connecting to OMRON C200H PLC
• Assembly and Connection of Communications Connector
Use the OMRON communications connector conforming to EMI standards that is provided with the
Controller. Prepare a connection cable and a connector for the host device.
Controller side
OMRON
XM2A-0901 Plug
(provided with
Controller)
Note 1. One set of connectors conforming to EMI standards is provided with the Controller.
Note 2. Use the above cable or an equivalent one with an external diameter of 7 mm.
Heat-resistive RFID System
30
User's Manual
Controller
Connecting device
9-pin male
Cables with connectors
Shield
(Shielded wire)
Connection cable
OMRON MX2S-0911
Hood (See note 1.)
(provided with Controller)
Connector Pin Arrangement
When Viewed from the Controller
C200H-ASC02
9-pin male
Recommended cable
Hitachi Cable's
CO-MA-VV-SB 5PX28AWG
(See note 2.)
Host device side