Adding Printers In Netware - Axis 5600 Plus User Manual

Adding Printers in NetWare

Section 6
42
Downloaded from www.Manualslib.com
Adding Printers in NetWare
This section describes how to continue the installation of the AXIS
5400+/AXIS 5600+ in the NetWare environment. Identify which transport
protocol you are running on your network and which installation method
you should use. Continue the installation by selecting the appropriate
installing instructions from the table below:
Installation
method
NDPS
iPrint
Queue-based
printing
See "NetWare Administration" on page 66 for information on Novell's
administration tools.
If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-
protocol, mixed environment, you should also proceed to the other
relevant sections in this manual.
manuals search engine
Transport
Action
protocol
See "Setup using NDPS" on page 43 and
TCP/IP
"Public Access Printers" on page 44
IPX/SPX
"Controlled Access Printers" on page 48
See "Setup using iPrint" on page 57 and
iPrint over LPR "Install a printer using AXIS LPR Gateway Configuration Snap-in"
on page 59
See "Setup using iPrint" on page 57 and
iPrint over IPP "Install a printer with AXIS IPP Gateway Configuration Snap-in"
on page 59
IPX/SPX
To install using the AXIS NetPilot Installation Wizard,
Basic
see "Basic Setup with AXIS NetPilot" on page 61
Configuration
IPX/SPX If you need a more advanced installation that is not covered by
Advanced the AXIS NetPilot Installation Wizard, see
configuration "Advanced Installation using AXIS NetPilot" on page 62
AXIS 5400+ / AXIS 5600+ User's Manual