Axis 5600 Plus User Manual page 114

Configuration Possibilities
To Update the Initial
114
Downloaded from www.Manualslib.com
2. Select Admin | Network Settings | Detailed View | SNMP Admin | Network Settings | Detailed View | SNMP Admin | Network Settings | Detailed View | SNMP and set SNMPv3 Admin | Network Settings | Detailed View | SNMP
Enabled Enabled Enabled Enabled to yes
3. Create an initial
password and one privacy password. Each password must consist of at least
8 characters.
4. Click the Create initial user Create initial user Create initial user button. Create initial user
Now your print server is ready to accept communication according to the
SNMPv3 protocol. For further management you will need an SNMPv3
management application; you use this application to configure the print
server, to create new user accounts and to control access to it. Also see
"Using SNMP" on page 95.
To update the initial user, select Admin | Network Settings | Detailed View
User | SNMP | SNMP | SNMP | SNMP, enter the two passwords (one for authentication and one for privacy)
and click the Update initial user Update initial user button.
Update initial user Update initial user
manuals search engine
yes. yes yes
initial user initial initial user by entering two new passwords: one authentication user user
Admin | Network Settings | Detailed View Admin | Network Settings | Detailed View Admin | Network Settings | Detailed View
AXIS 5400+ / AXIS 5600+ User's Manual
SNMPv3 SNMPv3 SNMPv3