Ports, Controls And Indicator Leds - Siemens RUGGEDCOM RX1501 Installation Manual

RUGGEDCOM RX1501
Installation Guide
• Input voltage ranges: 13-36 VDC and 37-72 VDC or 85-264 VAC and 88-300 VDC for worldwide operability
• CSA/UL 60950-1 safety approved to 85 °C (185 °F)
Section 1.2

Ports, Controls and Indicator LEDs

The RX1501 features various ports, controls and indicator LEDs on the front panel for configuring and
troubleshooting the device.
Figure 1: Front Panel
1. Management Port
6. Lamp Test/Alarm Cut-Off (LT/ACO) Button
Management Port
RS232 Serial Console Port
Utility USB Port
Lamp Test/Alarm Cut-Off (LT/ACO) Button
Power Module Indicator LEDs
Port Status Indicator LEDs
Alarm Indicator LED
Compact Flash Card Port
Ports, Controls and Indicator LEDs
1 2
2. RS232 Serial Console Port (DB9)
7. Compact Flash Card Port
This 10/100Base-T Ethernet port is used for system management that is out-of-band from
the switch fabric.
This port is for interfacing directly with the device and accessing initial management
functions.
The USB port can be used to upgrade the ROX II software or install files, such as
configuration files and feature key files.
This button performs two functions:
• Press and hold this button to test all indicator LEDs
• Press and release this button to acknowledge an active alarm
These LEDs indicate the status of the power modules.
• I = The power supply is receiving power
• O = The power supply is supplying power
These LEDs indicate when ports are active.
• Green = OK
• Orange = Warning alert
• Red = Configuration error
The alarm indicator LED indicates when an alarm condition exists.
• Green = Alarms cleared/acknowledged
• Red = Alarm
This port houses the 1 GB compact flash card that contains active and backup installations
of ROX II, along with the configuration database and other system data.
5 6
3 4 7
3. Utility USB Port 4. Port Status Indicator LEDs
Chapter 1
Introduction
5. Alarm Indicator LED
3