Mounting The Device To A Panel; Connecting Power - Siemens RUGGEDCOM RX1501 Installation Manual

Chapter 2
Installing the Device
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.1.3

Mounting the Device to a Panel

For panel installations, the RX1501 can be equipped with panel/DIN rail adapters pre-installed on each side of
the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
Figure 4: Panel Mounting
1. Screw 2. Panel/DIN Rail Adapter
2. Install the supplied screws to secure the adapters to the panel.
Section 2.2

Connecting Power

The RX1501 supports a single high AC, high DC or low DC power supply.
The RX1501 can be equipped with either a screw-type or pluggable terminal block. The screw-type terminal
block is installed using Phillips screws and compression plates, allowing either bare wire connections or crimped
terminal lugs. Use #6 size ring lugs for secure, reliable connections under severe shock or vibration.
8
1
1
RUGGEDCOM RX1501
Installation Guide
2
Mounting the Device to a Panel