Chapter 2
Installing Device
Figure 2: Rack Mount Adapters
1. Rear 2. Front 3. Rack Mount Adapter
2.
If required, install adapters on the opposite side of the device to protect from vibrations.
3.
Insert the device into the rack.
4.
Secure the adapters to the rack using the supplied hardware.
Section 2.3.2
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM M2200 can be equipped with panel adapters pre-installed on each side of
the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
Place the device against the panel and align the adapters with the mounting holes.
10
1
3
Installation Guide
2
3
Mounting the Device to a Panel
RUGGEDCOM M2200