View Mode - Crestron DM-MD8X8 Operation Manual

DigitalMedia™ Switchers
Switch Audio, Video & USB
Separately
View Source Routing
View Output Routing
70 DigitalMedia™ Switchers: DM-MD8X8/16X16/32X32
Changes made on the front panel are made only after the ENTER button is
pressed. If you do not press ENTER, the connection is not made.
Only one input can be routed at a time. Pressing a different input button will
lose any routing plans that were not confirmed by pressing the ENTER
button.
NOTE: If ENTER has not been pressed, you can go back and "undo"
changes made to the current routing.
5. Repeat for any other routes to be changed.
1. Press the AUDIO, VIDEO, or USB buttons to select the audio, video, or
USB portions to be switched. The respective LEDS will light.
NOTE: When audio is switched independently, the signal is 2-channel
audio.
2. Press the button corresponding to the input to be switched. The LED of the
selected input will light.
To turn off an output, deselect the input. The display will show "IN None"
and the input LEDs will be extinguished.
3. Press the button(s) corresponding to the output(s) to be switched. The
LED(s) of the selected output(s) will light.
If a button press will result in changing the current routing, the LEDs of the
newly selected outputs will flash and the display will state "Press ENTER
to Route".
4. Press ENTER to make the connection(s) shown on the front panel.
Changes made on the front panel are made only after the ENTER button is
pressed. If you do not press ENTER, the connection is not made.
Only one input can be routed at a time. Pressing a different input button will
lose any routing plans that were not confirmed by pressing the ENTER
button.
NOTE: If ENTER has not been pressed, you can go back and "undo"
changes made to the current routing.
5. Repeat for any other routes to be changed.

View Mode

Use the View Mode to view routing information for inputs and outputs. To select the
View mode, press the VIEW button.
1. Press an input signal button to display all of the outputs that are connected
to it.
2. Press AUDIO, VIDEO, or USB to see where the audio, video, or USB
portions of an input signal are routed.
1. Press an output signal button to display the input signal that is connected.
All outputs that are receiving the same input signal are also displayed.
2. Press AUDIO, VIDEO, or USB to see the input that is providing the audio,
video, or USB portions of the output signal.
Crestron DM-MD8X8/16X16/32X32
Operations Guide – DOC. 6755C