Inputs - Crestron DM-MD8X8 Operation Manual

DigitalMedia™ Switchers
Exit Installer Tools
42 DigitalMedia™ Switchers: DM-MD8X8/16X16/32X32
The Installer Tools menu is displayed.
Installer Tools
Installer Tools

Inputs

Outputs
Network
Installer Tools is separated into six sections:
Inputs: Configure and view the settings of input cards installed on
the DM switcher.
Outputs: Configure and view the settings of the output cards
installed on the DM switcher.
Network: Configure and view the Ethernet settings of the
DM switcher.
Control: Configures and views the settings of the DM switcher
front panel.
Message Log: Displays messages contained in the DM switcher
message log.
Commission System: Manages HDCP keys and optimizes EDID
settings for devices connected to the DM switcher.
NOTE: Changes made to any setting will only be saved upon exiting Installer
Tools. For instructions on exiting Installer Tools, refer below.
To exit Installer Tools, press the MENU button. Press the soft button labeled Yes to
save any changes and exit Installer Tools or press the soft button labeled No to return
to Installer Tools.
Inputs
The Inputs section of Installer Tools is used to configure and view information about
input cards installed on the DM switcher. Any changes made to the Inputs section
will be saved upon exiting Installer Tools. For more information on exiting Installer
Tools, refer to "Exit Installer Tools" above.
To open the Inputs section of Installer Tools:
1. Open Installer Tools as described on page 41.
2. Turn the selection knob to highlight Inputs and press the ENTER button. A
list of installed input cards will be displayed.
Crestron DM-MD8X8/16X16/32X32
Operations Guide – DOC. 6755C