Configuration - Crestron DM-MD8X8 Operation Manual

Crestron DM-MD8X8/16X16/32X32

Configuration

Open Installer Tools
Operations Guide – DOC. 6755C
After making all hardware connections, the DM switcher must be configured for
operation. The DM switcher can be configured from the DM switcher's front panel
using Installer Tools or from a PC using Crestron Toolbox. This document contains
instructions for using Installer Tools. For information on using Crestron Toolbox to
configure the DM switcher, refer to the Crestron Toolbox help file.
To open Installer Tools:
1. Press the MENU button.
2. Enter the password. The default password is 1234.
a. Use the selection knob and the soft buttons labeled
the password.
Enter Password
Enter Password
NOTE: If the password contains digits greater than 0 and less than 9,
the IN buttons (1 through 8) can be used to enter the password.
b. Turn the selection knob until the correct digit is displayed.
c. Press the button to move the cursor to the next digit and select the
next digit in the password with the volume control. Press the
to move to the previous digit.
d. Press the ENTER button once the password is displayed. If an
incorrect password is entered, the display will show "Invalid
Password". Press the soft button labeled OK to exit Installer Tools.
The password can be changed or disabled. For information on changing or
disabling the password, refer to "Password" on page 50 for more
information.
DigitalMedia™ Switchers: DM-MD8X8/16X16/32X32
DigitalMedia™ Switchers
0000
< >
and to enter
button
41