Loewe Connect ID 46 DR+ User Manual page 7

Connect ID 40-55 DR+
User guide
For your safety
Set-up
Loewe Flat TV sets are specified for Loewe accessories. The TV set is
suitable for different mounting options. Note the assembly instructions
regarding the different possible mounting options.
When using accessories from other manufacturers take care that the
TV set can be easily inclined or rotated on the respective mounting
option.
For mounting options from other manufacturers with motor drive,
make sure that the TV set cannot be rotated manually. The use of
mounting options from other manufacturers with locks in certain
positions is generally discouraged.
During the adjustment of the TV set it is es-
sential to ensure that the pressure exerted on
the device frame is not too large. Especially in
case of large-format displays there is a risk to
damage the screen.
Before setting up the device, please check that the final location is
suitable to bear the load of the device in terms of surface (sensitivity
to pressure) and stability (statics).
This is particularly the case for the high-gloss painted surfaces and
surfaces that are made from real wood / real wood veneer or plastic
surfaces.
Place the TV set with the table or floor stand only on a level, sturdy,
horizontal base. Particularly ensure that the set does not protrude
to the front when placed in or on pieces of furniture.
Place the TV set in a normal position for use. TV set may only be used
in an upright horizontal position. It may not be tilted by more than 10
degrees. The TV set must never be operated in portrait position, lying
flat or hanging overhead from the ceiling.
±10°
Set up the device where it is not exposed to direct sunlight and where
it is not exposed to additional warming through heating elements.
Mounting a Loewe flatscreen TV set to a holder according to the VESA
standard necessarily requires the use of Loewe Vesa adaptor bolts
to prevent damage to the TV set.
When mounting the TV set, always check that
all four Loewe Vesa adaptor bolts are used.
The Loewe Vesa adaptor bolts are used to
ensure stability and the necessary distance
between rear wall of the TV set and Vesa-Holder
(at least 5mm).
The Loewe Vesa adaptor bolts are fastened
with a torque of about 4 Nm on the TV set. If
you use a Vesa mounting options from other manufacturers, you can
order the Vesa adapter bolts M8x32 (No.
ized dealer of Loewe.
Supervision
Do not let children loiter and play unsupervised close to the device.
The set could tip over, be pushed off or pulled down from the stand
surface and injure someone.
Do not allow the switched-on TV set to run unattended.
Volume
Loud music can lead to ear damage. Avoid extreme volume espe-
cially over long periods and when using headphones.
) at your author-
90458.957
Thunder storms
Pull out the mains plug and all connected antenna cables from the
TV set in a thunderstorm. Overvoltage caused by lightning strokes
can damage the set via the antenna system, as well as via the mains.
The mains plug and all connected antenna cables should also be pulled
out during long periods of absence.
Automatic shutdown
If the TV is not operated for 4 hours (adjustment of volume, pro-
gramme change, etc.) the TV will automatically switch to stand-by
mode to save energy. A prompt to terminate this shutdown process
appears one minute before expiry of the 4 hours.
The automatic shutdown is generally active for the TV mode as soon as
the energy efficiency mode Home Mode is enabled for at least one of
the six signal input groups (see chapter Technical Data, section Signal
input groups). This also applies if another energy efficiency mode is
selected during initial installation, but one of the signal input groups is
subsequently set to Home Mode.
Automatic shutdown does not occur when using the radio without
screen display (screen off).
Cleaning and care
Switch off the TV set with the main switch prior to cleaning.
Clean the TV set, the screen, and the remote control unit with a soft,
moist, clean and colour-neutral cloth only, without any aggressive
or scouring cleaning agents.
The speaker panel of your TV set is covered with textile. Vacuum the
surface regularly using a soft brush set.
In case of dirt or stains:
Moisten a soft, colour-neutral cloth with detergent or normal stain
remover and gently rub away the stain. You can also treat the mark/
stain directly with normal dry stain remover spray (vacuum up pow-
der).
Do not moisten the covering fabric directly with detergent or stain
remover (risk of encrustation). Do not use any solvents to clean the
fabric.
Follow the manufacturer's instructions when using stain removers.
There is an increased risk of encrustation when cleaning speaker
panels with nicotine deposits.
Repairs and accessories
Never remove the back of the TV set yourself. Have your TV set re-
paired or serviced by authorised television technicians only.
Only use original accessories such as Loewe stands, if possible (see
chapter Accessories).
7