Loewe Connect ID 46 DR+ User Manual page 120

Connect ID 40-55 DR+
User guide
System settings
Connections
Setting the HiFi/AV amplifier
Sound playback via ... - HiFi/AV amplifier
The sound components wizard permits configuration of different
audio amplifiers (stereo amplifiers, surround amplifiers, analogue or
digital) with different digital audio formats (Dolby Digital, dts, MPEG,
and stereo/PCM). See the user guide of the audio amplifier for more
information.
For information on navigation within the wizard see
chapter General information on menu operation.
HOME: Call Home view.
Mark System settings,
OK call System settings.
Select Connections,
go to next column.
Select Sound components,
Call sound components wizard.
Sound
SOUND COMPONENTS WIZARD - Sound playback via ...
Please specify here via which sound components you want to listen to your
... ... Sound com-
reproduction
TV sound. If you select a "Speaker system", this must be connected to the
ponents
DIGITAL AUDIO LINK socket on the back of the TV set (with an additional
via ...
adapter if necessary).
Note: The newly selected parameter must be confirmed with the
button.
TV speakers
Speaker system
HiFi/AV amplifier
Soundprojector
HiFi/AV amplifier or TV speakers (switchable)
Proceed with
Mark HiFi/AV amplifier or HiFi/AV amplifier or
TV speakers (switchable),
OK Confirm selection.
HiFi/AV Select setting when an amplifier is connected and
amplifier the TV speakers are not used.
HiFi/AV Select setting when an amplifier is connected and
amplifier or the TV speakers are used. In the sound mode selec-
TV speakers tion the audio reproduction can then be switched
(switchable) between the amplifier and the TV speakers.
Proceed to next step.
Type of sound
Type of sound transmission
transmission Please select whether the TV sound signal should be transmitted to the
... Sound com-
HiFi/AV amplifier by a digital (via the SPDIF OUT) or analog (via the AUDIO
ponents
OUT) signal.
digital
Back with
Select whether the sound is to be transmitted
digitally or analogue to the the amplifier (see right
hand column):
digital: Proceed to Sound formats.
analogue: proceed to Type of amplifier.
120
OK
End with
analogue
Proceed with
Sound
Sound formats
formats
Please specify, what kind of sound formats can be processed by your
... Sound com-
HiFi/AV amplifier and mark them by the button
ponents
Stereo (PCM) Stereo (PCM)
dts
MPEG
Dolby Digital
Back with
Select sound formats which can be decoded with
the digital amplifier (see operating manual of the
used amplifier).
OK adopt sound formats.
Proceed to next step.
Amplifier
Amplifier Type
Type
Please specify which amplifier type is connected.
... Sound com-
ponents
Surround amplifier
Back with
Please select the amplifier type which is connect-
ed (surround or stereo amplifier).
Proceed to next step.
TV
TV loudspeakers as centre speaker
Please specify whether you want to use your built-in TV speakers as active
loudspeakers ... Sound com-
ponents centre speakers of your multi-channel speaker system. If so, connect the
centre output (pre-amplifier output, not speaker output) of the HiFi/AV
as centre
amplifier to the CENTER IN socket.
speaker
No
Back with
If surround was selected for type of amplifier:
For every connected surround amplifier, select whether
the TV loudspeakers are to be used as centre speakers.
If yes, establish a connection between the centre
output of the amplifier and the CENTER IN socket of
the TV set via a cinch cable.
Attention: Do not use the centre speaker con-
nection of the amplifier, use the centre pre-amp
output instead!
Back: Finish wizard.
.
OK
Proceed with
Stereo amplifier
Proceed with
yes
Finish wizard with