Loewe Connect ID 46 DR+ User Manual page 23

Connect ID 40-55 DR+
User guide
Initial installation
Setting options for DVB-C reception:
If you have not selected DVB-C antenna in the list of available antennas:
Proceed to Setting options for DVB-S reception.
If a CA module is plugged in during Initial installation and if the item
Stations in the special station list was selected in Extent of
station search, the station list of the CA module will be adopted.
Further settings described on this page will then be skipped. The
procedure of the initial installation will then be continued with the
step Setting options for DVB-S reception.
Network
selection
Network selection (DVB-C)
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the
Unitymedia
Standard
Back with
If several networks are available via DVB-C, you can
decide which network you want to receive your chan-
nels from. The normal DVB-C settings are derived from
the selection of the location or network and do not
need to be changed. Exactly which of the following
settings are present is dependent on which network is
selected.
Select network.
OK Confirm selection.
Proceed to next step.
Settings
DVB-C settings
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and additional
card.
Scrambled stations
Search method
Start frequency
Network ID
Accept Logical Channel Number
Back with
Select and adapt settings for DVB-C recep-
tion.
button.
OK
Proceed with
no yes
Network search Frequency search
044.00 MHz
none 00000
no yes
Proceed with
Scrambled You can state whether coded stations are to be
stations searched for in the search/update.
save all found scrambled stations. However, these
stations can only be received in connection with a CA
module and the appropriate Smart Card.
of the CA module is described in chapter Extras,
section CA module.
Search If you select Frequency search here, a search is
method performed for all receivable stations. With Network
search, only the stations which the networks supply
are searched - either for all receivable networks
or only for the particular network specified under
Network ID.
Start The DVB stations are only searched for in the fre-
frequency quency range above the start frequency.
Network ID If you select none here, DVB signals of all current
transmitter networks are searched automatically
(recommended for most cable networks).
If, on the other hand, you specify a certain network ID
(necessary in the cable networks of some countries),
only DVB signals of this broadcasting network are
searched for automatically.
Your cable provider has the information you need.
Accept In various countries, digital stations (DVB-C) are
Logical transmitted with a preset channel number per
Channel station, known as Logical Channel Numbers (LCN).
Number
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
Proceed to next step.
Select yes to
Handling
23