Loewe Connect ID 46 DR+ User Manual page 102

Connect ID 40-55 DR+
User guide
System settings
Control
Software update via Antenna
A software update via antenna is only available for stations of the
Freeview DVB-T platform in the UK and Ireland.
Calling Software update
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Control,
go to next column.
Mark Software,
go to next column.
Mark Software update,
go to next column.
Mark Via Antenna,
call Software update.
You will see a message on the screen regarding
data protection.
SOFTWARE UPDATE WIZARD - Current software
Current software: 2.1.25.0
... ... Via antenna
To load a new piece of software, you first need to search for said software on a
USB storage device that is connected (e.g. USB stick). Press the
the search.
Proceed with
Proceed.
The TV set searches for a new software package.
If a new software version is available after the search, an
on-screen message appears (see right hand column).
If no new software package was found in the search:
BACK: End of wizard.
New software package found
New software
A new software version was found. A new software version was found.
... ... Via antenna
New software: V2.3.14.0 (Current software: V.2.1.25.0) New software: V2.3.14.0 (Current software: V.2.1.25.0)
If you now wish to load the new software, press the If you now wish to load the new software, press the
close with the close with the
Ensure that the TV set is not switched off at the mains while it is loading the Ensure that the TV set is not switched off at the mains while it is loading the
data. data.
Proceed with Proceed with
Proceed starts loading of the new software.
Or:
BACK: End of wizard.
The update will then not be carried out.
102
key to start
Cancel with
button. Otherwise button. Otherwise
button. button.
End with End with
Load new software package
Updating software
The "V2.3.14.0" software is currently being programmed, please wait ...
Via antenna
... ...
Note: The loading and programming process can take up to approx. 50 minutes Note: The loading and programming process can take up to approx. 50 minutes
in total. Please do not switch off your TV set at the mains during this time. in total. Please do not switch off your TV set at the mains during this time.
The software is downloaded in several steps. The total
downloading and programming process can take up to
approx. 50 minutes in total.
Please do not switch off your TV set with the mains
switch during the entire loading and programming
process.
You will be informed at the end of the update.
To make your TV set completely ready for use again,
please turn it off and on again with the mains switch.
60%