Setting The Time And Date - Philips DVDR 77/00 User Manual

a
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Use C , D or the number buttons 0..9 on the
remote control to select the appropriate programme number (name) of the
TV channel and confirm with OK .
a
b The entered ShowView number is incorrect. Correct your entry or cancel
using the SYSTEM-MENU button.
b Check the time/date (see 'Setting the time & date' in 'Installing your DVD
recorder').
a
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
6
The decoded data appears after confirmation. You can go back and
change the data. Select the appropriate input field with C or D . If
required, make changes using A , B or the number buttons 0..9 .
' input field using C . Using SELECT switch on 'VPS/PDC'
Select the '
(' ' lights up). If you press SELECT again, you will switch 'VPS/PDC' off (' '
goes out).
' input field using C .
Select the '
Use REC MODE to select the recording mode '
'.
You can select also the recording mode '
With these setting the recording mode (bit rate) will be automatically
calculated to use the complete empty space (title '
If the empty space is too small the recording will be stopped to prevent the
following titles from being overwritten.
Do not use this function under the following conditions:
•) more then one programmed recording
•) daily/weekly repeated recordings
•) recordings with VPS/PDC
May be the calculation of the recording mode can not function properly.
7
If all information is correct, press the OK button. The programming
information is stored in a TIMER block.
8
To end, press TIMER s .
9
Insert a recordable disc (one without write protection).
The inserted disk is checked.
0
Search the position on the disc where the recording should begin.
Press STOP h .
A
Switch the DVD recorder off with STANDBY m .
The programmed recording will only function properly if the DVD
recorder has been
If any of the TIMER blocks are in use, '
, , , ,
' .
').
using the STANDBY m button.
' will light up on the recorder display.
Programming a recording (TIMER)
, ,