Connecting Additional Devices - Philips DVDR 77/00 User Manual

C
You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the
EXT 2 AUX-I/O socket. When playback is started on this additional device the DVD recorder
automatically connects the EXT 2 AUX-I/O scart socket with the EXT 1 TO TV-I/O scart
socket. You will then see the picture from the additional device on your TV set, even if the
DVD recorder is switched off.
The TV/DVD button on the remote control allows you to switch between playback through the
EXT 2 AUX-I/O scart socket and playback from the DVD recorder.
The DVD recorder must be connected
directly to the TV set). If there is a video recorder in between the picture quality may be poor
because of the copy protection system built into the DVD recorder.
You can connect a video recorder or a DVD player to the EXT 2 AUX-I/O input socket. If you
already have an external receiver (satellite receiver, set-top box, cable TV box) connected to this
socket, you can connect the video recorder to the 'VCR', 'TO VCR', ...socket of the external
receiver.
You can also use the front sockets S-VIDEO , VIDEO and the left AUDIO right audio
sockets.
Most prerecorded video cassettes and DVDs are copy-protected. If you try to copy them you
will see the message '
a
b Check that the cable is plugged in firmly.
b If a recording is made from a video recorder, change the tracking on the
video recorder.
b The DVD recorder may not be able to recognise the video input signal if
this signal is poor or does not comply with relevant standards.
a
b This happens if you try to copy DVDs or video cassettes that have been
copy-protected. Even though the picture on the TV is fine the recording on
a DVD+RW/+R
copy-protected DVDs or video cassettes.
to the TV set ( EXT 1 TO TV-I/O socket
' on the DVD recorder's display.
is faulty. This interference

Connecting additional devices

is unavoidable with