Philips DVDR 77/00 User Manual page 99

PROBLEM
Programming a recording (TIMER)
SOLUTION
b
While a programmed recording is being made, you cannot operate your DVD recorder manually.
If you want to cancel the programmed recording, press STANDBY m .
b
The DVD recorder was switched on a few minutes before the start of a programmed recording.
Switch off the DVD recorder using STANDBY m . A programmed recording (timer) will only
function if the DVD recorder is switched off ( STANDBY m button).
b
Either a disc has not been inserted or the disc cannot be used for recording. Insert a disc on
which recordings can be made.
Search the position on the disc where you want the recording to begin.
Switch off the DVD recorder using STANDBY m .
b
A write-protected disc has been inserted. Undo the write protection (see 'Preventing accidental
erasing of discs' in 'Manual recording') or insert a different disc.
b If this error message appears after pressing TIMER s , then all TIMER blocks are already
programmed. No more recordings can be programmed. Press the C button. If you want to clear
or check a programmed recording (TIMER block), select it with A or B .
b
The data for the recording could not be transferred. Please check date, start time and finish time
of the programmed recording.
b
Two programmed recordings overlap.
b
If you ignore this error message the show with the earlier start time will be recorded first. The
start of the second show will not be recorded.
b
Change the setting for either of the two recordings.
b
Clear either of the two recordings