Removing The Seat; Mounting The Seat - Husqvarna FE 450 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.18

Removing the seat

12.19

Mounting the seat

–
Position the frame protectors on the left and right.
–
Mount and tighten screws
Guideline
Screw, frame protector
–
Mount and tighten screws
Guideline
Screw, frame protector
K00589-11 –
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Remove the air filter box cover. (
Main work
–
Remove screw
–
Pull seat back and lift it off.
F00296-10
Main work
–
Mount the front of the seat on the collar bushing of the fuel tank, lower the seat at
the rear, and push the seat forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
F00297-10
Finishing work
–
Install the air filter box cover. (

.

with the washers.
p. 56)

.

.
p. 56)
M5 3 Nm (2.2 lbf ft)
M5 3 Nm (2.2 lbf ft)
p. 75)
p. 45)
M6 10 Nm (7.4 lbf ft)
55