Table of Contents
Advertisement
11
TUNING THE CHASSIS
11.15
Handlebar position
11.16
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Guideline
Spring preload - Preload Adjuster
Comfort
Standard
Sport
The adjusting wings engage noticeably at the numerical values.
Info
Adjust the spring preload to the numerical values only as the preload will
not engage between the numerical values.
Turn clockwise to increase the spring preload; turn counterclockwise to
reduce the spring preload.
Adjusting the spring preload has no influence on the absorption setting of
the rebound damping.
Basically, however, you should set the rebound damping higher with a
higher spring preload.
Finishing work
–
Remove the motorcycle from the lift stand. (
On the upper triple clamp, there are two holes at a distance of
Hole distance
The holes on the handlebar supports are placed at a distance of
Hole distance
The handlebar supports can be mounted in four different positions.
101859-10
–
Remove screws
lay it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
101860-10
Guideline
Screw, handlebar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
15 mm (0.59 in)
3.5 mm (0.138 in)
. Take off the handlebar clamps. Take off the handlebar and
. Take off the handlebar supports.
.
M10
+0
+0
+3
p. 45)
to each other.
from the center.
40 Nm
Loctite
(29.5 lbf ft)
43
®
243™
Hide quick links:
Advertisement
Table of Contents
