Recommended Work - Husqvarna FE 450 Owner's Manual

10 SERVICE SCHEDULE
Check idle.
Check that the radiator fan is functioning properly.
Final check: Check the vehicle is roadworthy and take a test ride.
Read out the fault memory after the test ride using the Husqvarna Motorcycles diagnostics tool.
Make the service entry in the Husqvarna Motorcycles Dealer.net and in the Service and Warranty Booklet.
○
One-time interval
●
Periodic interval
10.3

Recommended work

Change the front brake fluid.
Change the rear brake fluid.
Change the hydraulic clutch fluid.
Lubricate the steering head bearing.
Service the fork.
Service the shock absorber.
Perform engine service including removing and installing the engine. (Change the spark plug and spark
plug connector. Change the piston. Check/measure the cylinder. Check the cylinder head. Change the
valves, valve springs, and valve spring seats. Check the camshaft, rocker arm and rocker arm shafts.
Change the connecting rod, conrod bearing, and crank pin. Change the shaft seal ring of the water
pump. Check the transmission and shift mechanism. Check the oil pressure regulator valve. Change
the suction pump. Check the force pump and lubrication system. Check the timing assembly. Change
the timing chain. Change all engine bearings. Change the freewheel.)
○
One-time interval
●
Periodic interval
Every 45 operating hours/every 10 operating hours when used for motorsports
( p. 69)
( p. 51)
Every 30 operating hours/after every race
Every 70 operating hours when used for motorsports
Once after 10 operating hours
Every 15 operating hours
Once after 1 operating hour
Every 135 operating hours
○ ●
●
36
○ ● ●
○ ● ●
○ ● ●
○ ● ●
○ ● ●
Annually
●
●
●
●
● ●
● ●
● ●