15
ELECTRICAL SYSTEM
15.5
Changing the fuses of individual power consumers
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
–
Take off protection caps
–
Remove faulty main fuse
Info
You can recognize a defective fuse by a burned-out fuse wire
A spare fuse
–
Install a new main fuse.
Fuse (58011109120) (
–
Check that the electrical equipment is functioning properly.
Tip
Insert a spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and route the cable.
F00358-10
Finishing work
–
Mount the seat. (
–
Install the air filter box cover. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the air filter box cover. (
–
Remove the seat. (
Main work
–
Pull EFI control unit
F00359-10
–
Open fuse box cover
–
Remove the defective fuse.
Guideline
(FE EU)
Fuse 1 ‑ 10 A - EFI control unit, lambda sensor, speedometer, combination
switch (optional), fuel injection, diagnostics connector, fuse 4
(FE AU)
Fuse 1 ‑ 10 A - EFI control unit, speedometer, combination switch
F00360-10
(optional), fuel injection, diagnostics connector, fuse 4
Fuse 2 - 10 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 3 - 10 A - radiator fan, horn, brake light, turn signal
Fuse 4 - 5 A - fuel pump
Fuses res - 10 A - spare fuse
Info
You can recognize a defective fuse by a burned-out fuse wire
.
.
is located in the starter relay.
p. 114)
p. 55)
p. 56)
p. 56)
p. 55)
from the holder and hang it to one side.
.
88
.
.