Activating Launch Control; Activating Traction Control - Husqvarna FE 450 Owner's Manual

Table of Contents

Advertisement

9
RIDING INSTRUCTIONS
9.3

Activating Launch Control

Warning
Voiding of the government approval for road use and the insurance coverage If the combination switch is installed,
the vehicle's approval for road use is invalidated.
Only operate the vehicle in closed-off areas remote from public road traffic if the combination switch is installed.
Info
The Launch Control assists the rider to optimally accelerate the motorcycle at the beginning of a race. The maximum speed
of the engine with the throttle valve fully opened (full throttle) is reduced. After the start, it is gradually increased up to the
maximum engine speed. The rider opens the throttle fully throughout this procedure. The clutch must be activated exactly
as it would be without an active Launch Control.
9.4

Activating traction control

Warning
Voiding of the government approval for road use and the insurance coverage If the combination switch is installed,
the vehicle's approval for road use is invalidated.
Only operate the vehicle in closed-off areas remote from public road traffic if the combination switch is installed.
Info
The traction control reduces excessive slip on the rear wheel in favor of more control and propulsion, particularly in wet con-
ditions.
When traction control is switched off, the rear wheel may spin more during high acceleration and on surfaces with low grip.
Traction control can be switched on or off during the ride.
The setting most recently selected is activated again when restarting.
Press the electric starter button.
Info
Press the electric starter button for a maximum of 5 seconds. Wait for 30
seconds before a further attempt at starting.
At temperatures below 15 °C (60 °F), several attempts at starting may be
necessary to warm-up the lithium-ion battery and thereby increase the
starting power.
During the starting process, the malfunction indicator lamp lights up.
400733-01
Condition
The motorcycle is stationary.
The engine is running at idle speed.
Transmission in neutral
Press and hold MAP and TC buttons simultaneously.
FI warning lamp flashes orange rapidly.
Info
Several seconds after the vehicle starts, Launch Control is deactivated
automatically.
The Launch Control is deactivated in the following cases (FI warning lamp
no longer flashes): After full throttle, the throttle valve was closed by more
than 1/3 of the way and/or there is no start within 3 minutes.
To reactivate Launch Control, the engine must first be switched off for
H01179-10
at least 10 seconds for safety reasons. This must occur regardless of
whether the engine was started or not.
31

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe 501

Table of Contents