Changing The Engine Oil And Oil Filter, Cleaning The Oil Screens - Husqvarna FE 450 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.3

Changing the engine oil and oil filter, cleaning the oil screens

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Drain engine oil with engine at operating temperature.
Main work
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before checking the level.
The engine oil is at a level between the lower edge
the level viewer.
»
If the engine oil is not up to the lower edge
F00438-10
–
Add engine oil. (
Preparatory work
–
Remove the engine guard. (
–
Park the motorcycle on a level surface.
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
F00441-10
–
Remove screw plug
Info
Do not remove screw
F00442-10
–
Remove screw plug
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
F00443-10
p. 105)
p. 70)

with the magnet and seal ring.

with the short oil screen and the O-rings.

.
 with the long oil screen
 
and the middle

of the level viewer:
 and the O-rings.
103
of