Table of Contents
Advertisement
10 TUNING THE CHASSIS
10.16
10.17
42
Handlebar position
800116-10
Adjusting the handlebar position
B00375-10
Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
–
1
Mount protection cap
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance
B
of
from the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Preparatory work
–
Remove the handlebar cushion.
Main work
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handle-
M10
bar support
–
Position handlebar.
17 clicks
12 clicks
7 clicks
.
2
.
40 Nm (29.5 lbf ft)
®
Loctite
A
243™
Advertisement
Table of Contents
