Asr 5000 System Administration Guide, Staros Release 21.1 - Cisco ASR 5000 Administration Manual

Configuring Event Log Filters
• facility facility and level severity_level – Configure the logging filter that determines which system
facilities should be logged and at what levels. For detailed information, see
page 170
• all | instance instance_number – Specifies whether logging will be disabled or enabled for all instances
or a specific instance of aaamgr, hamgr or sessmgr. Run the show session subsystem facility facility
command to identify specific instance numbers.
Note
• level severity_level – Specifies the level of information to be logged from the following list which is
ordered from highest to lowest:
Note
• critical-info – Specifies that events with a category attribute of critical information are to be displayed.
Examples of these types of events can be seen at bootup when system processes and tasks are being
initiated. This is the default setting.
no-critical-info – Specifies that events with a category attribute of critical information are not to be
displayed.
Note
To enable logging of a single instance of a facility, you must first disable all instances of the facility
Important
(logging filter disable facility facility all) and then enable logging of the specific instance (logging filter
enable facility facility instance instance_number. To restore default behavior you must re-enable logging
of all instances (logging filter enable facility facility all).
You can display the instance numbers for enabled instances per facility using the Exec mode show
instance-logging command.

ASR 5000 System Administration Guide, StarOS Release 21.1

168
and Event Severities, on page
These keywords are only supported with the disable and enable keywords.
• critical - display critical events
• error - display error events and all events with a higher severity level
• warning - display warning events and all events with a higher severity level
• unusual - display unusual events and all events with a higher severity level
• info - display info events and all events with a higher severity level
• trace - display trace events and all events with a higher severity level
• debug - display all events
This keyword is only supported in conjunction with the active keyword.
These keywords are only supported in conjunction with the active keyword.
195.
System Logs
Specifying Facilities, on