Configuring An Atm Port For An Ss7 Link; Binding An Ss7 Link To An Atm Port; Verifying Port And Interface Configuration - Cisco ASR 5000 Administration Manual

System Interfaces and Ports
Notes:
• The context must be the one you used when creating the IP interface (PVC) for the ATM port.

Configuring an ATM Port for an SS7 Link

Use the following example to configure an ATM port to use with an SS7 (Signalling System No. 7) link:
configure
port atm slot#
Notes:
• The PVC for the SS7 link has been created but can not be bound unless the SS7 routing domain
• Complete optional ATM port configuration (see the ATM Port Configuration Mode Commands chapter

Binding an SS7 Link to an ATM Port

Use the following example to bind an already configured SS7 link to a PVC interface for an ATM port:
configure
port atm slot#
Notes:
• Save the configuration as described in the Verifying and Saving Your Configuration chapter.

Verifying Port and Interface Configuration

Step 1 Verify that your interface configuration settings are correct by entering the following commands:
host_name
[local]
context_name
[ ]
context_name represents the name of the context in which the interface was created. The output from these commands
should look similar to that displayed in the following example.
no shutdown
bind interface ifc_name ctx_name
end
port#
/
no shutdown
pvc vpi vpi_num vci vci_num
no shutdown
end
configuration has already been completed (see the SGSN Administration Guide).
in the Command Line Interface Reference) and the other steps in this procedure to set timing and save
the configuration.
port#
/
pvc vpi vpi_num vci vci_num
bind link ss7-routing-domain ss7rd_id linkset-id id link-id id
end
context context_name
#
host_name show ip interface
#
Configuring an ATM Port for an SS7 Link
ASR 5000 System Administration Guide, StarOS Release 21.1
105