Epson BrightLink 697Ui User Manual page 325

On/Standby Status light
light
Blue Flashing blue
Blue Off
Flashing blue Off
Blue Varies
Off Flashing blue
Lamp light Temp light
Off Off
Off Off
Off Off
Off Flashing
orange
Off Orange
325
Status and solution
Warming up. Wait for an image to
appear.
Shutting down. (When the Status light
stops flashing, you can unplug the
projector.)
Standby, sleep mode, or monitoring.
Preparing for monitoring; all features
are disabled.
Projector is too hot.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• Make sure the environmental
temperature is not too hot.
Projector has overheated and turned
off. Leave it turned off to cool down.
After about five minutes, do the
following:
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• If operating the projector at high
altitude, turn on High Altitude
Mode.
• If the problem persists, unplug the
projector and contact Epson for
help.