Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Dodge Charger SRT 392 2017 Owner's Manual

4. Current Gear
• On
• Off (default)
5. Odometer
• Show (default)
• Hide
6. Gear Display
• Full (default)
• Single
7. Restore Default
• Ok
• Cancel
Speed Warning — If Equipped
Push and release the up or down arrow button until the
Speed Warning Menu icon/title is displayed in the instru-
ment cluster display. Push and release OK to enter speed
warning. Use up or down arrow button to select a desired
speed, then push and release OK to set the speed. The
Manual Speed Assist (MSA) Speed Warning telltale will
display in the instrument cluster display, and a chime will
sound with a pop up warning message when the set speed
is exceeded.
UNDERSTANDING YOUR INSTRUMENT PANEL 231
NOTE: You can turn the Speed Warning off by using the
up/down arrows to scroll through speed list and select
OFF at the bottom of the list.
Battery Saver On/Battery Saver Mode Message —
Electrical Load Reduction Actions — If Equipped
This vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or
the vehicle battery conditions are deteriorating, electrical
load reduction actions will take place to extend the driving
time and distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical loads.
Load reduction is only active when the engine is running.
It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due to
lack of electrical supply, or will not restart after the current
drive cycle.
When load reduction is activated, the message "Battery
Saver On" or "Battery Saver Mode" will appear in the
instrument cluster.
4