Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Dodge DURANGO 2020 Owner's Manual

Defaults (Restores All Settings To Default
Settings)
Restore

Cancel

Diagnostics — If Equipped
Push and release the up or down arrow button
until the Diagnostics icon/title is highlighted in
the instrument cluster display. Push and
release the OK button to display the diagnostic
trouble codes and descriptions. When the end
of the list is reached, "No or End of Diagnostic
Code" will appear in the instrument cluster
display.
SRT Speed Warning — If Equipped
Push and release the up or down arrow button
until the Speed Warning Menu icon/title is
highlighted in the instrument cluster display.
Push and release the OK button to enter speed
warning. Use the up or down arrow button to
select a desired speed, then push and release
the OK button to set the speed. When the set
speed is exceeded, the indication will light up
yellow and flash along with a pop up message of
"Speed Warning Exceeded" with a continuous
chime (until the speed is no longer exceeded).
B S O /B
ATTERY AVER N ATTERY
M M — E
ODE ESSAGE LECTRICAL
R A — I E
EDUCTION CTIONS F
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.
Load reduction is only active when the engine is
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
When load reduction is activated, the message
"Battery Saver On" or "Battery Saver Mode" will
appear in the instrument cluster.
GETTING TO KNOW YOUR INSTRUMENT PANEL
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
S
AVER
system cannot sustain.
L
OAD
NOTE:
QUIPPED
The charging system is independent from

load reduction. The charging system
performs a diagnostic on the charging
system continuously.
If the Battery Charge Warning Light is on it

may indicate a problem with the charging
system. Refer to "Battery Charge Warning
Light" in this chapter for further information.
The electrical loads that may be switched off (if
equipped), and vehicle functions which can be
affected by load reduction:
Heated Seat/Vented Seats/Heated Wheel

Rear Defroster And Heated Mirrors

HVAC System

115 Volt AC Power Inverter System

Audio and Telematics System

105
3