Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Dodge CHALLENGER 2020 Owner's Manual

86 GETTING TO KNOW YOUR INSTRUMENT PANEL
Diagnostics — If Equipped
This feature allows the driver to view engine and
emission vehicle faults.
Push OK to have the most recent fault code

sent.
There is a delay when the next diagnostic

code is requested during which the following
message is displayed:
"Checking System for Diagnostic Codes."
Driver must push the OK button again to see

the next Pcode otherwise current message
remains displayed.
Driver exits when they cycle to another

submenu (up or down).
Faults are displayed from newest to the oldest.

If the menu is exited before the end of codes

is reached - when the driver re-enters the list
will be restarted from the beginning.
When no codes are present or the last code

is reached = (P0000) and this message is
displayed:
"No or End of Diagnostic Codes."
Speed Warning — If Equipped
Push and release the up or down arrow button
until the Speed Warning Menu icon/title is
displayed in the instrument cluster display.
Push and release OK to enter speed warning.
Use the up or down arrow button to select a
desired speed, then push and release OK to set
the speed. The white passive speed limiter
telltale will light up with a notification text
message (Speed Warning Set to XX), followed by
the selected unit. When the set speed is
exceeded, an audible chime will sound for up to
10 seconds or until the speed is no longer
exceeded. The white passive speed limiter
telltale will turn yellow and will flash, and a pop
up message of "Speed Warning Exceeded" will
display.
NOTE:
You can turn the Speed Warning off by using the
up or down arrows to scroll through speed list
and select OFF at the bottom of the list.
B S O /B
ATTERY AVER N ATTERY
M M — E
ODE ESSAGE LECTRICAL
R A — I
EDUCTION CTIONS F
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions will
take place to extend the driving time and distance
of the vehicle. This is done by reducing power to
or turning off non-essential electrical loads.
Load reduction is only active when the engine is
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
When load reduction is activated, the message
"Battery Saver On" or "Battery Saver Mode" will
appear in the instrument cluster.
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
S
AVER
L
OAD
E
QUIPPED