Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Dodge CHARGER 2020 Owner's Manual

92 GETTING TO KNOW YOUR INSTRUMENT PANEL
4. Current Gear
On

Off (default)

5. Odometer
Show (default)

Hide

6. Gear Display
Full (default)

Single

7. Restore Defaults
OK

Cancel

Speed Warning — If Equipped
Push and release the up or down arrow button
until the Speed Warning Menu icon/title is
displayed in the instrument cluster display. Push
and release OK to enter speed warning. Use the
up or down arrow button to select a desired
speed, then push and release OK to set the
speed. The white passive speed limiter telltale
will light up with a notification text message
(Speed Warning Set to XX, followed by the
selected unit). When the set speed is just
exceeded, a single chime will sound with a pop
up message of "Speed Warning Exceeded". If the
set speed is exceeded by 1.5 mph (3 km/h), an
audible chime will sound for up to 10 seconds or
until the speed is no longer exceeded. The white
passive speed limiter telltale will turn yellow and
will flash, and a pop up message of "Speed
Warning Exceeded" will display.
NOTE:
You can turn the Speed Warning off by using the
up/down arrows to scroll through speed list and
select OFF at the bottom of the list.
Diagnostics — If Equipped
This feature allows the driver to view engine and
emission vehicle faults.
Push OK to have the most recent fault code

sent.
There is a delay when the next diagnostic

code is requested during which the following
message is displayed:
"Checking System for Diagnostic Codes."
Driver must push the OK button again to see

the next P code otherwise current message
remains displayed.
Driver exits when they cycle to another

submenu (up or down).
Faults are displayed from newest to the

oldest.
If the menu is exited before the end of codes

is reached - when the driver re-enters the list
will be restarted from the beginning.
When no codes are present or the last code

is reached = (P0000) and this message is
displayed:
"No or End of Diagnostic Codes."
Battery Saver On/Battery Saver Mode
Message — Electrical Load Reduction
Actions — If Equipped
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.