Checking The Quicksilver Mercathode System - Mercury 350 MAG Manual

MerCathode System— Electrode assembly replaces the Anode block. System should be tested to ensure adequate output. The
test should be performed where boat is moored, using Quicksilver Reference Electrode and Test Meter.
Description
Gearcase anode plate
Ventilation plate anode
MerCathode System
Anode kit (if equipped)
Trim cylinder anodes
Bearing carrier anode (Bravo One)
Propshaft anode (Bravo Three)

Checking the Quicksilver MerCathode System

The MerCathode system should be tested to ensure adequate output. Perform the test where boat is moored, using the reference
electrode and test meter. Contact your authorized Mercury MerCruiser dealer for service and information .
90-8M0050539 MAY 2011
eng
Location
Mounted on the underside of the lower
gearcase.
Mounted on the front of the gearcase.
The MerCathode electrode is mounted
to the underside of the gimbal housing.
The MerCathode controler is mounted
on the engine or on the boat transom.
The controler harness connects to the
electrode harness.
Mounted to the boat transom.
Mounted on each of the trim cylinders.
Located in front of the propeller,
between the front side of the propeller
and the gear housing.
Located behind the aft propeller.
Section 5 - Maintenance
Figure
20336
20338
20340
20341
20342
20343
20344
Page 111