Mercury 350 MAG Manual page 169

Predelivery Inspection Checklist, Continued
Check/
N/A Item
Adjust
On-the-Water Test
⃞ ⃞ Engine alignment (Inboard models only)
⃞ Starter neutral safety switch operation
⃞ E‑stop switch/lanyard stop switch operation (all helms)
⃞ Seawater pump operation
⃞ Operation of instruments
⃞ Fuel, oil, and water leaks
⃞ Exhaust leaks
⃞ Ignition timing
⃞ Forward, neutral, and reverse gear operation
⃞ Steering operation throughout range
⃞ Acceleration from idle RPM is normal
⃞ WOT________ RPM within specification (in forward gear)
⃞ ⃞ EC models: run two full operating cycles (key on/off) to WOT with engine at normal operating temperature while
monitoring engine with G3 CDS to verify engine goes into closed‑loop engine control.
⃞ ⃞ Power trim operation
⃞ ⃞ Boat handling
After On-the-Water Test
⃞ Propeller nut tightened to specification
⃞ Fuel, oil, coolant, water and fluid leaks
⃞ Oil and fluid levels
⃞ Apply Quicksilver Corrosion Guard to engine package
⃞ Operation, Maintenance & Warranty manual in boat
If Boat Is Registered to a Resident of California
⃞ ⃞ CARB hang tag in boat
⃞ ⃞ CARB decal properly affixed to boat hull
90-8M0050539 MAY 2011
eng
Section 9 - Checklists
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Page 161