Mercury 350 MAG Manual page 116

Section 5 - Maintenance
Tube Ref No.
Special Lubricant 101
34
Anti-Corrosion Grease
94
2-4-C Marine Lubricant
95
with Teflon
3. Align splines and place propeller on propeller shaft.
4. Install and torque the propeller nut. Check propeller at least every 20 hours of operation and retorque as needed.
Description
Forward propeller nut
5. Slide aft thrust hub onto propeller shaft, with tapered side toward propeller hub (toward end of shaft).
6. Align splines and place propeller on propeller shaft.
7. Install and torque the propeller nut. Check propeller at least every 20 hours of operation and retorque as needed.
Description
Aft propeller nut
8. Install the propeller shaft anode over the propeller shaft nut.
9. Place the flat washer onto the propeller shaft anode screw.
10. Place the star washer onto the propeller shaft anode screw.
11. If a propeller shaft anode is reinstalled, apply Loctite Threadlocker 271 to the threads of the propeller shaft anode screw.
b
c
d
f
e
Tube Ref No.
Loctite 271 Threadlocker
7
12. Secure the propeller shaft anode to the propeller shaft using the propeller shaft anode screw and washers. Torque the screw.
Description
Propeller shaft anode screw 38 mm (0.3125‑18 x 1.5 in.) long
Page 108
Description
Description
Where Used
Propeller shaft
Propeller shaft
Propeller shaft
a - Propeller
b - Propeller shaft nut
c - Propeller shaft anode
d - Propeller shaft anode screw
e - Flat washer
f - Star washer
a
5303
Where Used
Propeller shaft threads
Part No.
92-802865Q02
92-802867Q 1
92-802859A 1
Nm lb‑in.
136 –
Nm lb‑in.
81 –
Part No.
92-809819
Nm llb‑in.
27 –
90-8M0050539 MAY 2011
eng
lb‑ft
100
lb‑ft
60
lb‑ft
20