Bravo Three Propeller Installation - Mercury 350 MAG Manual

3. Remove the propeller shaft anode.
b
c
d
f
e
4. Turn aft propeller shaft nut 37 mm (1‑7/16 in.) counterclockwise to remove nut.
5. Slide propeller and thrust hub off propeller shaft.
6. Turn front propeller shaft nut 70 mm (2‑3/4 in.) counterclockwise to remove nut.
7. Slide propeller and thrust hub off propeller shaft.
NOTE: Some damaged propellers can be repaired. Contact your authorized Mercury MerCruiser dealer.
b
a
i
j
g h

Bravo Three Propeller Installation

Operating the engine with a loose propeller can damage the propeller, the drive, or drive components. Always tighten the
propeller nut or nuts to specification and check for tightness periodically and at the required maintenance interval.
b
a
i
j
g h
1. Slide forward thrust hub onto propeller shaft with tapered side toward propeller hub (toward end of shaft).
2. Apply a liberal coat of one of the following lubricants to the propeller shaft.
90-8M0050539 MAY 2011
eng
e
f
d
c
e
f
d
c
a - Propeller
b - Propeller shaft nut
c - Propeller shaft anode
d - Propeller shaft anode screw
e - Flat washer
f - Star washer
a
5303
a -
b -
c -
d -
e -
f -
g -
h -
i -
j -
5304
NOTICE
a -
b -
c -
d -
e -
f -
g -
h -
i -
j -
5304
Section 5 - Maintenance
Rear propeller nut
Rear propeller
Rear propeller thrust hub
Front propeller nut
Front propeller
Front propeller thrust hub
Propeller shaft anode screw
Flat washer
Star washer
Propeller shaft anode
Rear propeller nut
Rear propeller
Rear propeller thrust hub
Front propeller nut
Front propeller
Front propeller thrust hub
Propeller shaft anode screw
Flat washer
Star washer
Propeller shaft anode
Page 107