Section 5 - Maintenance
Reference Electrode
Power Package Exterior Surfaces
1.
Spray the entire power package at recommended intervals with Corrosion Guard. Follow the instructions on the can for proper
application.
Tube Ref No.
Corrosion Guard
120
2.
Clean the entire power package. External surfaces that have become bare should be repainted with the recommended primer
and spray paint at recommended intervals.
Description
Mercury Light Gray Primer
Mercury Phantom Black
Boat Bottom Care
To achieve maximum performance and fuel economy, the boat bottom must be kept clean. Accumulation of marine growth or
other foreign matter can greatly reduce boat speed and increase fuel consumption. To ensure best performance and efficiency,
periodically clean the boat bottom in accordance with manufacturer's recommendations.
In some areas, it may be advisable to paint the bottom to help prevent marine growth. Refer to the following information for special
notes about the use of anti‑fouling paints.
Anti‑fouling Paint
IMPORTANT: Corrosion damage that results from the improper application of anti‑fouling paint will not be covered by the limited
warranty.
You may apply anti‑fouling paint to the boat hull and boat transom but you must observe the following precautions:
IMPORTANT: Do not paint or pressure‑wash the anodes or the MerCathode System reference electrode and anode. Doing so
will render them ineffective as inhibitors of galvanic corrosion.
Page 112
Senses and electrical current in the water when testing the MerCathode system.
Use to check hull potential.
9188
Description
91‑76675T 1
Where Used
Painted surfaces
Painted surfaces
Part No.
92-802878 55
Part Number
92‑802878 52
92‑802878Q 1
90-8M0050539
MAY 2011
eng