Shift Tray Operation: Stand-By Mode - Ricoh D014 Service Manual

DETAILS

3.9.2 SHIFT TRAY OPERATION: STAND-BY MODE

Standby Mode
When the machine is switched on:
1. The shift tray lift motor switches on and lowers the tray.
2. The feeler [A] descends and raises the hooked actuator [B] out of the gap of
Sensor and switches Sensor
3. When Sensor switches ON this reverses the shift tray motor.
4. The shift tray motor raises the shift tray and pushes up the feeler, the actuator
descends into the gap of Sensor , and switches Sensor
5. When Sensor switches OFF, this stops the shift tray lift motor with the shift
tray at the standby position.
This sequence repeats every time the machine is powered on.
Sensor also switches off the shift tray lift motor when the machine is switched on
with the shift tray removed for servicing. When the machine is switched on without
the shift tray attached to the side of the finisher:
1. The shift tray mount will push the feeler [A] up until the actuator [B] enters the
gap of Sensor and switches Sensor 2 ON.
2. When Sensor switches ON this switches the shift tray motor OFF and stops
the tray.
NOTE: Sensor
used to switch off the shift tray motor and stop the shift tray mount.
B830
CÓPIA NÃO CONTROLADA
[B]
ON.
cannot operate with the shift tray removed so Sensor
54
CÓPIA NÃO CONTROLADA
[A]
B830D010.WMF
OFF
is
SM