Z-Fold Adjustment Procedure; 1St Fold Adjustment - Ricoh D014 Service Manual

1.13.3 Z-FOLD ADJUSTMENT PROCEDURE

1st Fold Adjustment

1. Print one A3 copy and send it through
the Z-fold unit.
2. Open the 2nd fold
3. Turn the paper over so the edge
aligned with the crease of the 2nd fold.
4. Open the right door and locate the
screw that adjusts the 1st fold (see
previous page).
5. Use a plus screwdriver to turn the
screw [A] to the left to loosen the nut.
• If the corner is over the right edge,
turn the screw to the right.
• If the corner is over the left edge,
turn the screw to the left.
NOTE:
• The illustration above shows the
corner over the right edge.
• You can see the pointer [B] change
position on the notches of the
adjustment scale as you turn the
screw.
6. Close the Z-Fold unit.
7. Do another test print.
8. If the 1st fold is still misaligned, repeat
this procedure until the alignment is
correct.
9. After the adjustment is completed, use
a screw driver to hold the screw in
position, then retighten the nut you
loosened in Step 2. Do not turn the
screw.
SM
CÓPIA NÃO CONTROLADA
.
is
15
CÓPIA NÃO CONTROLADA
REPLACEMENT AND ADJUSTMENT
1
2
3
[A]
[B]
1
3
B660R215.WMF
B660R220.BMP
B660