Shift Tray Operation: Z-Folded Paper - Ricoh D014 Service Manual

3.9.5 SHIFT TRAY OPERATION: Z-FOLDED PAPER

[A]
Sensor and its feeler [A] and actuator [B], and Sensor
flat actuator [D] control the movement of the shift tray when Z-folded paper is
output to the shift tray.
1. Z-folded paper is output to the tray.
2. As the height of the stack increases, this pushes up feeler [A] of Sensor
3. When the actuator [B] of the ascending feeler enters the gap of Sensor
switches the sensor OFF and switches the tray lift motor ON.
4. The tray lift motor lowers the tray until the feeler descends far enough to raise
the actuator out of the gap of Sensor
5. When the actuator leaves the gap of Sensor
switches the motor OFF, and stops the tray.
6. Steps 1 to 5 repeat until the top of the paper stack pushes feeler [C] up and
actuator [C] into the gap of Sensor
7. When the actuator enters the gap of Sensor
switches Sensor
SM
CÓPIA NÃO CONTROLADA
[B]
.
.
OFF, signals that the tray is full and stops the job.
57
CÓPIA NÃO CONTROLADA
[C]
[D]
B830D010.WMF
with its feeler [C] and
, this switches Sensor
, this switches the sensor off and
DETAILS
.
, this
ON,
B830